This is a draft site

This Pertronic Modbus interface allows a LIOS DE.TECT fibre-optic linear heat detection system (LHD) to be integrated into a Pertronic F220 fire system.

The interface connects to the fire panel's RS-485 bus and communicates with the LHD via Modbus. It can be mounted inside the fire panel or at a remote location.

The interface uses the fire panel's loop emulation capability. Each zone on the LHD cable is mapped to a device on an emulated analogue addressable loop.

The Modbus connection is galvanically isolated from the fire alarm control panel’s RS-485 bus.

Features

• Compatible with Pertronic F220 fire alarm control panels
• Functions as a Modbus master device
• Modbus connection configurable RS-232 or RS-485, 300 bit/s to 115,200 bit/s
• Supports Modbus TCP when connected to a Modbus Serial to Modbus TCP Gateway
• Emulates up to four analogue addressable loops. (Note that the total number of actual and emulated loops cannot exceed the panel’s maximum loop capacity)
• Supports
  • Up to 159 fibre-optic LHD detection zones per emulated loop (maximum 4 x 159)
  • Two module addresses representing the LHD controllers global Alarm and Fault indications on the base loop only
• Each zone on the LHD cable is mapped to a device on an emulated analogue addressable loop
• Each emulated heat detector can report pre-alarm and fibre break as well as alarm signals
• Optional fault supervision between the fibre-optic LHD interface and fire alarm control panel
• Configurable with a PC running a terminal emulation program via USB mini-B cable
• On-board LEDs provide diagnostic information
• Electrically isolated from the fire alarm control panel’s RS-485 bus
• Also compatible with F120A fire panels with v5.0 or later firmware

---