M500MAP Module
For use in intelligent, two-wire systems, providing an interface to contact devices
M210EA-CZR Module
Intelligent conventional zone interface. Connects a zone of conventional smoke detectors to an intelligent system. Built-in isolator for the intelligent loop
M500DMAP Module
Dual input (monitor) intelligent addressable module. Monitors two independent contact sets. Input circuits are supervised for open circuit faults. Compatible with the Pertronic F220 fire panel.
M500RAP module
Relay control module for use in intelligent, two-wire systems where the individual address of each module is selected using built-in rotary switches.
M500SAP Module
Used to switch an external power supply, which can be a DC power supply or an audio amplifier (up to 80 VRMS) to notification devices.
M501MAP Module
With its small size and light weight, the M501MAP can be installed in a single gang junction box directly behind the monitored unit.
M502MAP Module
Detection zone interface. Monitors one conventional detection zone. Reports zone status (normal, fault, alarm) to intelligent addressable fire panel. Compatible with the Pertronic F220 fire panel.
M500X Fault Isolator
Isolator Module enables part of the communications loop to continue to operate when a short circuit occurs on it.
IM-10 Module
Ten input (monitor) intelligent addressable module. Monitors ten individually addressable contact sets. Input circuits are supervised for open circuit faults. Compatible with the Pertronic F220 fire panel.
CR-6 Module
Six output (control) intelligent addressable module. Controls six individually addressable volt-free form C (change-over) contact sets. Unsupervised output wiring. Compatible with the Pertronic F220 fire panel.
SC-6 Module
Six output (control) intelligent addressable module. Controls six individually addressable ac, dc, or audio loads. Supervised output wiring. Compatible with the Pertronic F220 fire panel.
CZ-6 Six Zone Interface Module
An interface between an intelligent alarm system and a conventional alarm loop. Ideal for retrofit applications to monitor zones of conventional two-wire detectors, where status conditions are reported as normal, open or alarm.